Trendnet AC1750 Guide de l'utilisateur télécharger pdf (Page 34)

TRENDnet User’s Guide

TEW-815DAP

• Frequency Band: Select the operating wireless frequency you would like to repeat.

• Network Name (SSID): Enter the wireless network name of the signal you would

like to repeat.

• Security Mode: Select and configure the wireless security settings of the wireless

signal you would like to repeat.

4. Wait for the device to apply the settings.

5. To verify the access point has successfully copied the settings and repeated the signal

of your wireless network, wait for the Link Status to display Connected. It may take up

to 1 minute for your device to verify and display the connection status.

Note: If the Link Status does not display a Connected status after 1 min, please re-

attempt the procedure.

• Link Status: Displays the connection status of the device either Connected or

Disconnected.

• MAC Address: Displays the MAC address of the TEW-815DAP

• Network Name (SSID): Displays the wireless network name

• Radio Band: Displays the operating wireless radio band used

• Channel Width: Display the channel width of the repeated signal

• Channel: Displays the wireless channel used

• Bit Rate: Displays the estimated connection bit rate

• Signal: Displays the connection signal strength

• Security: Displays the wireless security used.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 58 59

Pas de commentaire

Trendnet AC1750 Guide de l'utilisateur Page 34