Trendnet Router TEW-610APB Manuel d'utilisateur télécharger pdf (Page 4)

1. Locate an optimum location for the Access Point. The best place for the

Access Point is usually at the center of your wireless network.

2. Connect the RJ-45 network cable to the Access Point, then connect the

other end of the network cable to a Switch or Hub. The Access Point is now

connected to your 10/100Mbps network.

3. Connect the power adapter to the Access Point. Make sure you use the

power adapter supplied with the Access Point; using a different power

adapter may damage the unit.

2. Install Hardware

Make sure the front panel lights are on: Power, LAN, MIMO.

Verify Hardware Installation

NOTE: If you are using a wired computer to configure the Access Point,

please connect this computer to the same Switch or Hub the

TEW-610APB is connected to.

POWER

MIMO

LAN

TEW-610APB

English

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Trendnet Router TEW-610APB Manuel d'utilisateur Page 4