Trendnet TK-RP08 Guide d'installation télécharger pdf (Page 9)

Troubleshooting

Q1:

A1:

Q2:

A2:

Q3:

A3:

Q4:

A4:

Q5:

A5:

My AC-powered device does not power on after I press on the power button for the

power outlet on the TK-RP08. What should I do?

First, make sure the provided power cord is plugged into the TK-RP08 and into the

power outlet. Second, make sure the AC powered device is properly plugged into one of the

power outlets on the TK-RP08. Third, make sure to press the power button for at least two

seconds before releasing. Fourth, press the reset button on the TK-RP08.

I double click on the IP Power Manager icon, but I am unable to make a connection.

What should I do?

First, make sure the computer is connected to the serial port on the TS-RP08. Second,

connect the RS-232 cable to a different serial port on the computer. Third, connect to a

different computer.

The Alarm LED is red. What should I do?

First, turn off and disconnect the device attached to the corresponding power outlet.

Press the power button to the corresponding power outlet several times. Second, press on

the reset button on the back.

The Current LED is flashing. What should I do?

The maximum allowable current load – 15 amps – has been exceeded. Try shutting

down some devices to keep the current below 15 amps.

Can I use HyperTerminal to configure the TK-RP08?

Yes you can. The port settings must be configured as shown below:

Bits Per Second: 9600

Data bits: 8

Parity: None

Stop bits: 1

Flow Control: Hardware

Please refer to the User Guide on the Utility CD-ROM for list of commands. Make sure

to exit out of the IP Power Management Utility first.

If you still encounter problems or have any questions regarding the TK-RP08, please contact

Trendnet's Technical Support Department.

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Trendnet TK-RP08 Guide d'installation Page 9